Polaris 2015 GEM eM1400 LSV - Manual (Page 62)

60
MAINTENANCE
Lights
Brake Lights
When the brake pedal is depressed, the brake light comes on. Check the brake light before
each ride.
1. Turn the key to the ON position.
2. Apply the brakes. If the light doesn't come on, check the wiring, the brake switch or the
taillight assembly.
Indicator Panel Lamp Replacement
1. Lift the hood.
2. Reach in behind the console panel and lift the
release to unplug the light from the harness.
3. Using a flathead screwdriver, press on the tab on
the top of the light to remove the indicator light
assembly from the console panel.
4. Locate the expired lamp. Using a screwdriver,
rotate the lamp 1/4 turn counter-clockwise.
5. Grip the lamp with a needle-nose pliers and
remove it from the assembly.
6. Install the new lamp. Using a screwdriver, rotate the lamp 1/4 turn clockwise to seat it.
7. Snap the assembly back into the console panel. Reconnect the harness.
8. Close the hood.
Front and Rear Turn Signal Light Replacement
If a front or rear turn signal fails to work properly, the entire assembly must be replaced. See
your authorized GEM dealer for this service.
Tab
Release