Features and controls, Seat belts – Polaris 2015 GEM eM1400 LSV User Manual

Page 32

Advertising
background image

30

FEATURES AND CONTROLS

Seat Belts

Failure to properly use seat belts can result in serious injury or death. Always follow all legal
requirements for seat belt use in on-road vehicles.

• Always make sure the seat belts are secured for operator and all passengers before operating.
• Pregnant women should wear the lap part of the belt across the thighs and as snug across the hips

as possible. Keep the belt low so that it does not come across the abdomen.

Proper Seat Belt Use

This vehicle is equipped with three-point lap and
diagonal seat belts for all occupants. Always make
sure the seat belts are secured for operator and all
passengers before operating. To wear the seat belt
properly, follow this procedure:

1. Pull the seat belt latch downward and across

your chest toward the buckle at the inner edge of
the seat. Slide the buckle up the webbing as far
as needed for the belt to reach across your hips.
The belt should fit snugly across your hips and
diagonally across your chest. Make sure the belt
is not twisted.

2. Push the latch plate into the buckle until it

clicks.

3. Release the strap, it will self tighten.

4. To remove slack in the lap belt portion of the

belt, pull upward on the shoulder belt. To loosen
the lap belt if it is too tight, tilt the buckle and
pull the lap belt slightly longer.

5. To release the seat belt, press the square red button in the buckle's center. If necessary,

slide the buckle down the webbing to allow it to retract fully.

WARNING

Buckle

Latch

Plate

Advertising
This manual is related to the following products: