Polaris 2015 GEM eM1400 LSV - Manual (Page 33)

31
FEATURES AND CONTROLS
Seat Belts
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly
into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including
cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not
operate properly, have the seat belt system checked and/or replaced by your authorized
GEM dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water.
Do not use bleach, dye or household detergents.
Occupant Protective
Structure (OPS)
The Occupant Protective Structure
(OPS) on this vehicle meets OSHA
1928.53 rollover performance
requirements. Always have your
authorized GEM dealer thoroughly
inspect the OPS if it ever becomes
damaged in any way.
No device can assure occupant
protection in the event of a rollover.
Always follow all safe operating
practices outlined in this manual to
avoid vehicle rollover.
WARNING! Vehicle rollover could cause severe injury or death. Always avoid operating in a manner
that could result in vehicle rollover.
OPS