HEIDENHAIN SW 54843x-02 - Manual (Page 419)

HEIDENHAIN MANUALplus 620 419
5.12 F
a
ce cont
ours in smar
t.T
u
rn
Linear pattern on face
You can find the reference dimension ZR with the "select reference
plane" function (see page 411).
ICP generates:
 The FRONT section code with the reference dimension parameter.
In nested contours, ICP generates only one section code.
 A G308 with the parameters contour name and milling depth (–
1*BT).
 A G401 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
Reference data of face
ID
Contour name
PT Milling depth
ZR Reference dimension
Parameters of pattern
XK, YK
1st point of pattern (Cartesian coordinates)
QP Number of points in pattern
IP, JP End point of pattern (Cartesian coordinates)
IPi, JPi Distance between two pattern points (in XK, YK
direction)
AP Position angle
RP Total length of pattern
RPi Distance between two pattern points
Parameters of the selected figure/hole