Elite VRVD640G - Manual (Page 36)

36
Advanced settings / Display Options (Page
103). See the following list for your options.
The only restriction is that you cannot se-
lect a value that already appears in another
fi eld. The possible fi eld contents are:
• Distance to destination (default value for
the left fi eld)
• Time to destination (estimated time en
route, default value for the middle fi eld)
• Distance to next via point
• Time to next via point
• Time to next maneuver (next route event)
• Speed
• Speed limit
• Arrival at next via point
• Arrival at destination (default value for the
right fi eld)
Distance to Next Turn (No. 17)
This fi eld shows the distance to go before
reaching the next route event (turn, round-
about, exit, etc.)
This fi eld is only displayed when navigating
a route.
Approaching Next Turn (No. 18)
This bar is only visible when approach-
ing the next route event. It appears on the
screen to visualise the distance when you
get closer than 300 meters (1000 feet) to
the next turn, and it remains visible till you
reach the turn. This fi eld is displayed only
when navigating a route.
Map Scale
The scale indicator is only available on the
Map screen. In 2D map view it represents
the scale of the map. In 3D view it is the
scale of the nearest part of the map only.
You can use it in both 2D and 3D modes
to scale the map. Drag and pull it right to
zoom in, or left to zoom out.
Route Information Screen
The Route Information screen has all the
data and some of the functions you need
while you navigate. Some additional func-
tions can be found in the Route menu.
Without an active route one of the buttons
is inactive and route data cannot be dis-
played.
As a reminder, you can open this screen
two ways: tapping the Info button in the
Route menu, or tapping one of the Route
Data fi elds on the Cockpit screen.
Route Data Displayed (for destination
and via points)
In the top section of the screen you see
information about the current route. These
fi elds are continuously updated while you
keep this screen open.
When you open the screen, all fi elds con-
tain information on reaching your fi nal des-
tination. Touch any of the fi elds to see data
on the via points starting from the fi rst one
through the fi nal destination again.
Route Line
The upper part of this screen shows your
planned route as a horizontal line. Its left-
most point is the start of the route, the right-
most one is the fi nal destination, and you
can see your via point fl ags along the line,
spaced in proportion to their distance.
The blue (yellow at night) arrow represent-
ing your position will travel from the left to
the right, giving you visual feedback of your
journey.
When you reach a via point, it becomes the
starting point of the route, the past will be
deleted, the line with all the other via points
will be modifi ed instantly, and the arrow
jumps back to the left.
When Cydle needs to recalculate the route,
the arrow will not jump back to the left as
when reaching a via point, but it may drift
a bit as the length of the new route may be
different from the previous one.
When the data corresponding to the entire
route is displayed in the fi elds below, the
line is coloured the same way as the route
line shown on the map. When you see data
that belongs to a via point, the route is co-
loured only up to that via point. The rest of
the line remains grey.
Navigation System