Elite VRVD640G - Manual (Page 48)

48
Unpaved Roads
Unpaved roads are excluded by default, as
they can be in a bad condition and you usu-
ally cannot reach the speed limit on them.
Motorways
When driving a slow car or towing another
vehicle, you may prefer not to take motor-
ways.
Ferries
The accessibility of temporary ferries is
not necessarily included in the map data.
Furthermore you may need to pay fare, so
you may consider disabling them from the
preset enabled status.
U-Turns
Although displayed amongst road types,
this is a type of action. Most drivers prefer
to replace them with a few normal left and/
or right turns in the next few junctions, so it
is disabled by default.
Turning back on dual carriageways is not
considered as a u-turn.
NOTE: If you are not totally against u-turns,
leave them on here, and add a certain pen-
alty (equivalent extra distance to travel) in
Advanced settings Route options.
NOTE: Via points are handled as stopovers
with regards to u-turns. It means disabling
u-turns on this page will avoid u-turns dur-
ing the entire route if possible, but when
reaching a via point, the following part of
the route may be planned starting in the
opposite direction.
Permit Needed
To use some roads or enter some areas
you may need special permit or permission
from the owners. These roads are excluded
from your routes by default. Use this switch
if your vehicle is authorised to enter.
Toll Roads
Toll roads are included in your routes by
default. If you wish to travel more to avoid
paying a toll, disabling them will make Cy-
dle plan the best toll-free route for you.
NOTE: You have a few more ways to infl u-
ence routing and route recalculation in Ad-
vanced settings Route options.
LANGUAGE & UNITS
Here you can set the languages, measure-
ment units, and date and time formats used
by Cydle.
Program Language
This button displays the current written lan-
guage of the program. By tapping the but-
ton you can select from a list of available
languages. Cydle will have to be restarted
if you change this setting. Cydle will ask for
confi rmation before it restarts.
Voice Language
This button shows the current language of
the voice guidance. By tapping the button
you can select from a list of available lan-
guages and speakers. Touch any of these
to hear a sample voice prompt. Just touch
OK when you have selected the new spo-
ken language.
Units
You can set the distance units to be used
by the program. Cydle may not support all
of the listed units in some voice guidance
languages. If you select a measurement
unit that is not supported by the chosen
voice guidance language, you will see a red
warning message under the selector.
Set Date & Time Format
You can set the date and time format dis-
Navigation System