HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 177)

HEIDENHAIN TNC iTNC 530 177
6.2 F
undamentals of P
a
th F
unctions
Radius compensation
The radius compensation must be in the block in which you move to
the first contour element. You cannot begin radius compensation in a
circle block. It must be activated beforehand in a straight-line block
(see “Path Contours—Cartesian Coordinates” on page 182).
Pre-positioning
Before running a part program, always pre-position the tool to prevent
the possibility of damaging it or the workpiece.