HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 495)

HEIDENHAIN iTNC 530 495
12.5 Set
ting the D
a
ta Int
e
rf
aces
Software for data transfer
For transfer of files to and from the TNC, we recommend using the
HEIDENHAIN TNCremoNT data transfer software. With TNCremoNT,
data transfer is possible with all HEIDENHAIN controls via the serial
interface or the Ethernet interface.
System requirements for TNCremoNT:
„ PC with 486 processor or higher
„ Operating system Windows 95, Windows 98, Windows NT 4.0,
Windows 2000
„ 16 MB RAM
„ 5 MB free memory space on your hard disk
„ An available serial interface or connection to the TCP/IP network
Installation under Windows
8 Start the SETUP.EXE installation program with the File Manager
(Explorer).
8 Follow the setup program instructions.
Starting TNCremoNT under Windows
8 Click <Start>, <Programs>, <HEIDENHAIN Applications>,
<TNCremoNT>
When you start TNCremoNT for the first time, TNCremoNT
automatically tries to set up a connection with the TNC.
You can download the current version of TNCremoNT free
of charge from the HEIDENHAIN Filebase
(www.heidenhain.de, <service>, <download area>,
<TNCremo NT>).