HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 58)

58 2 Manual Operation and Setup
2.2 Mo
ving the Mac
h
ine Ax
es
Incremental Jog Positioning
With incremental jog positioning the TNC moves the currently active
handwheel axis by a preset distance defined by you.
8 Press the handwheel soft key F2 (STEP)
8 Activate incremental jog positioning: Press handwheel soft key 3
(ON)
8 Select the desired jog increment by pressing the F1 or F2 key. If you
press and hold the respective key, each time it reaches a decimal
value 0 the TNC increases the counting increment by a factor of 10.
If in addition you press the Ctrl key, the counting increment
increases to 1. The smallest possible jog increment is 0.0001 mm.
The largest possible is 10 mm
8 Confirm the selected jog increment with soft key 4 (OK)
8 With the + or – handwheel key, move the active handwheel axis in
the corresponding direction
Entering Miscellaneous Functions M
8 Press the handwheel soft key F3 (MSF)
8 Press the handwheel soft key F1 (M)
8 Select the desired M function number by pressing the F1 or F2 key
8 Execute the M function with the NC start key
Entering the spindle speed S
8 Press the handwheel soft key F3 (MSF)
8 Press the handwheel soft key F2 (S)
8 Select the desired speed by pressing the F1 or F2 key. If you press
and hold the respective key, each time it reaches a decimal value 0
the TNC increases the counting increment by a factor of 10. If in
addition you press the Ctrl key, the counting increment increases to
1000
8 Activate the new speed S with the NC start key
Enter the feed rate F
8 Press the handwheel soft key F3 (MSF)
8 Press the handwheel soft key F3 (S)
8 Select the desired feed rate by pressing the F1 or F2 key. If you
press and hold the respective key, each time it reaches a decimal
value 0 the TNC increases the counting increment by a factor of 10.
If in addition you press the Ctrl key, the counting increment
increases to 1000
8 Confirm the new feed rate F with the handwheel soft key F3 (OK)