HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 49)

49
D
e
fining Machining O
p
erations
Additional parameters on the drilling parameters detail form:
8 Angle of spindle: Angle at which smarT.NC positions the tool before
it is plunged into or retracted from the bore hole.
8 Dwell time at counterbore floor
Globally effective parameters on the global data detail form:
8 Set-up clearance
8 2nd set-up clearance
8 Feed rate for positioning
8 Feed rate for traversing between machining positions