HEIDENHAIN TNC 620 (73498x-02) - Manual (Page 328)

Programming: Q Parameters
9.12 Preassigned Q parameters
9
328
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
Tool measurement with the BLUM
laser Parameter value
Reserved Q190
Reserved Q191
Reserved Q192
Reserved Q193
Reserved for internal use Parameter value
Marker for cycles Q195
Marker for cycles Q196
Marker for cycles (machining patterns) Q197
Number of the last active measuring
cycle Q198
Status of tool measurement with TT Parameter value
Tool within tolerance Q199 = 0.0
Tool is worn (LTOL/RTOL is exceeded) Q199 = 1.0
Tool is broken (LBREAK/RBREAK is
exceeded) Q199 = 2.0