HEIDENHAIN TNC 640 (34059x-01) Cycle programming - Manual (Page 295)

HEIDENHAIN TNC 640 295
13.7 TURN, L
O
NGITUDIN
AL PLUNGE (Cy
c
le 813)
Finishing cycle run
1 The TNC runs the infeed motion at rapid traverse.
2 The TNC finishes the finished part contour (contour starting point
to contour end point) at the defined feed rate Q505.
3 The TNC returns the tool to set-up clearance at the defined feed
rate.
4 The TNC positions the tool back at rapid traverse to the cycle
starting point.
Please note while programming:
Program a positioning block to a safe position with radius
compensation R0 before the cycle call.
The tool position at cycle call (cycle starting point) affects
the area to be machined.
The TNC takes the cutting geometry of the tool into
account to prevent damage to contour elements. If
complete machining with the active tool is not possible, a
warning is output by the TNC.
Also refer to the fundamentals of turning cycles (see
page 286).