Calling a program section repeat – HEIDENHAIN TNC 640 (34059x-02) ISO programming User Manual
Page 238
Advertising
Programming: Subprograms and program section repeats
8.3
Program-section repeats
8
238
TNC 640 | User's Manual for DIN/ISO Programming | 5/2013
Calling a program section repeat
Press the LBL CALL key
To call subprograms/section repeats: Enter the
label number of the subprogram to be called,
then confirm with the ENT key. If you want to
use a label name, press the " key to switch to text
entry If you want to enter the number of a string
parameter as target address: Press the QS soft
key; the TNC will then jump to the label name that
is specified in the string parameter defined
Repeat REP: Enter the number of repeats, then
confirm with the ENT key
Advertising