LeMond RevMaster Pro - Manual (Page 14)

14
Adjusting the fit
Take a moment to learn how to properly fit your RevMaster to your body; it will make your workouts a
more pleasant and safer experience. The RevMaster provides more seat and handlebar adjustability than
any other indoor group cycle, and each adjustment is numbered so you can quickly return the adjust-
ments to your specific settings. Making full use of these features will give you the most comfortable ride
possible and allow you to exercise efficiently. Using the bike when it is incorrectly adjusted can result in
unnecessary discomfort and increase your risk of injury.
!
WARNING: DO NOT ATTEMPT TO MAKE ANY ADJUSTMENTS TO THIS EQUIPMENT WHILE
SITTING OR STANDING ON THE BIKE. DISMOUNT THE BIKE PRIOR TO MAKING ALL
ADJUSTMENTS.
Seat Adjustment:
Adjusting the Seat’s height
Stand next to the seat post and adjust the seat to hip height. 1.
Rotate the crank so that the pedals are in the vertical, 12 and 6 o’clock, 2.
position.
Place your foot in the toe cage of the pedal closest to the floor and
3.
mount the bike. Ensure that the ball of your foot is over the center of
the pedal. Your leg should be slightly bent at the knee (155 ° extension),
as shown in the picture to the right.
If your leg is too straight or your foot cannot touch the pedal you will
4.
need to lower the seat. If your leg is bent too much you will need to
raise the seat.
Dismount
5. the bike and pull up on the seat post cam clamp lever. Once loosened, slide the seat post
up or down as necessary.
When the seat is in the desired position, push the cam clamp lever down to the locked position to
6.
secure the seat post.
Note the final position mark on the seat post for future reference.
7.
OpERATING INSTRUCTIONS