LeMond RevMaster Pro - Manual (Page 21)

21
TROUBLEShOOTING
SYMpTOM: Seat or handlebar post move after locked into position.
Locate smaller 3mm hex bolt at pivot point of cam handle and loosen 1 turn. 1.
Disengage 6mm hex bolt on other side from indicator plate and rotate one notch towards (+) sign. 2.
Tighten smaller 3mm hex bolt. 3.
Test post and repeat process if needed until post no longer moves. 4.
SYMpTOM: Clicking noise with each pedal revolution.
Check shoelaces to make sure the aglet is not tapping the bike as the pedals turn. 1.
Assure pedal straps are tight and that no excess strap on inner part of pedal is catching on the crank 2.
arm as it turns.
Assure that pedals are tight on crank arms.
3.
SYMpTOM: Clicking noise when flywheel rotates.
Check edge of flywheel that brake pad rubs against for small burrs. 1.
If burr is present gently remove while being careful not to damage flywheel surface. 2.
If symptom persists check for noisy flywheel bearings. 3.
If flywheel bearings are noisy or rough have authorized service technician replace flywheel hub as- 4.
sembly.
SYMpTOM: Drive belt is slipping.
Remove belt cover. 1.
Note: Use caution around belt when cover is removed.
Loosen idler with 8mm hex and tighten tensioner bolt 2-3 turns with 5mm hex wrench.
2.
Tighten idler and test belt. 3.
If belt still slips repeat process until belt no longer slips. 4.
Reinstall belt cover. 5.
SYMpTOM: knocking noise or play felt in pedals/cranks.
Make sure pedals are tight on crank arms. 1.
Note: Left pedal is reverse threaded.
Make sure crank bolts are tight. If loose, apply blue Loctite 242 to threads and tighten crank bolts
2.
with 8mm hex wrench.
If problem persists check the bottom bracket bearing cups for looseness. Tighten if necessary with
3.
a bottom bracket tool and use blue Loctite 242 on threads.
If knocking noise still persists contact authorized service technician for replacement of bottom
4.
bracket bearings.
TROUBLEShOOTING