LeMond RevMaster Pro - Manual (Page 19)

19
MAINTENANCE INSTRUCTIONS
heLPfuL hints
The safety level given by the design of this equipment can only be maintained when the equipment is
regularly examined for damage and wear. Inoperable components should be replaced immediately or
the equipment should be put out of use until it is repaired. Read all maintenance instructions thoroughly
before beginning work.
All references to the right or left side and to the front or back are made as if you were on the exercise
equipment ready to exercise. For example, the belt is on the right side of the bike.
tOOL List
The following tools are needed to perform service and maintenance:
15mm Pedal Wrench or Open End Wrench •
Metric Hex Key Set (up to 8mm) •
#2 Phillips Screwdriver •
Bottom Bracket Tool (Park BBT-2 or comparable 20-Tooth Tool) •
Crank Puller (Park CCP-2 or comparable Puller for Square, Tapered Spindles) •
Loctite 242 Medium Strength threadlocker •
Brake Pad Oil or 3-In-One Oil •
initiAL seRVice
Upon receiving your equipment, use a soft clean cloth to wipe off the dust that may have accumulated
during shipping. Your equipment will need minor assembly. Refer to the “Assembly Instructions” section
of this manual for details.
MAINTENANCE