Linkskey LKR-604 - Manual (Page 7)

6
RESET
Use a pin-shaped object to reset this device to factory default settings.
Resetting the device will also reset the login password to the default.
LAN (1-4) Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either
10Mbps or 100Mbps Ethernet connections.
WAN On the 4 port broadband router, there is an RJ-45 10/100Mbps
Auto-MDIX WAN port. This port connects to your xDSL/Cable modem.
POWER Connects the supplied AC adapter to the power input jack.
1.4 System Requirements

One or more PCs (desktop or notebook) with Ethernet interface.

TCP/IP protocol must be installed on all PCs.

Have valid Internet Access account and a DSL/Cable modem.

10/100BaseT Ethernet network cable with RJ-45 connector.

System with Microsoft Internet Explorer 6.0 or higher.
1.5 Installation Instruction
1) Power off the router and DSL/Cable modem.
2) Connect systems to the LAN ports on the router with straight Ethernet LAN cables.
3) Connect the DSL /Cable modem to the WAN port on the router.
4) Power on DSL/Cable modem firstly, wait for a minute until the modem is ready then power on
the router.
5) Check LEDs:
a) Once power on the router, Power LED should be on.
b) LAN LED should be on for each active LAN connection.
c) The WAN LED should be on when the DSL/Cable modem is connected.