Enterasys Networks Enterasys Matrix 9034310-01 - Manual (Page 20)

Network Expansion Module (NEM) Option
1-4 Introduction
Network Expansion Module (NEM) Option
The 2G4082‐25 option slot provides access to an installed network expansion module. Refer to the
Enterasys Networks web site for a current listing of the available NEMs. Specific installation
instructions are shipped with each NEM.
Connectivity
Depending on how the 2G4082‐25 is configured, it can support up to:
• 24, 10BASE‐T/100BASE‐TX/1000BASE‐T switched ports connected through 24, fixed RJ45
front panel connectors, or
• 24, 10BASE‐T/100BASE‐TX/1000BASE‐T switched ports plus an optional network expansion
module.
Management
Management of the module can be either in‐band or out‐of‐band. In‐band remote management is
possible using Telnet, Enterasys Networks’ NetSight
®
management application, or WebView™
application. Out‐of‐band management is provided through the RJ45 COM (Communication) port
on the front panel using a VT100 terminal or a VT100 terminal emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an intuitive web
tool for simple management tasks.
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete switch configuration management
tasks.
For CLI command set information and how to configure the module, refer to the Enterasys Matrix
DFE‐Diamond/Platinum Series Configuration Guide.