Enterasys Networks Enterasys Matrix 9034310-01 - Manual (Page 36)

Connecting to COM Port for Local Management Connecting to Modem
3-12 Installation
Figure 3-9 Connecting a VT Series Terminal
Connecting to a Modem
To connect a modem to an Enterasys Networks DFE‐Platinum module COM port ( Figure 3‐10 ),
use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25 male adapter, and
proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM port of
the DFE‐Platinum module.
2. Plug the RJ45 connector at the other end of the UTP straight‐through cable into the RJ45‐to‐
DB25 modem adapter.
3. Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
4. Turn on the modem.
5. With a PC connected to a remote modem, you can configure the switch remotely. To
accomplish this, you must configure your PC VT emulation package with the following
parameters.
6. When these parameters are set, the Local Management password screen will display. Refer to
the Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide for further information.
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB25 VT adapter
2 RJ45 COM port 4 VT series terminal
А В Г
2G4082-25
Gb ENET
COM
OFFLINE/
RESET
MGMT CPU
1
2
GROUP
SELECT
1X
11X 12X
G
R
O
U
P
1
GROUP
1
2
3
4
5
6
7
8
9
10
11
Á
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit