Auriol Z31743A_B - Manual (Page 16)

16 GB
Mounting the weather station and / or
the outdoor sensor on a wall:
Note: You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK OF
INJURY AND MATERIAL DAMAGE! Read
the operating and safety instructions for your drill
carefully.
DANGER TO LIFE! Take care
that you do not hit electricity, gas or water lines
when you drill into the wall. If necessary, check
with a pipe and cable detector before drilling.
Weather station
Mark the position of the hole (ø approx. 6 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel 27 into the drilled hole.
Using a crosshead screwdriver, screw the
screw
26 into the dowel.
Hang the weather station by placing the
hanger
23 on the screw.
External sensor
Mark the position of the hole (ø approx. 6 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel 32 into the drilled hole.
Using a crosshead screwdriver, screw the
screw
31 into the dowel.
Hang the external sensor by placing the
hanger
29 on the screw.
96385_aur_Temperaturstation_content_PL_HU_SI_CZ_SK.indd 16 13.01.14 12:33