EverFocus EMV1200 - Manual (Page 55)

47
4.4.2 Alarm-Event Settings
This section covers notifications due to internal system event warnings.
Figure 4-10 Alarm – Event Settings
Event: Select from the following event types.
Fan Failure: Fan is not working.
HD Temperature: Hard drive is over the safety warning temperature.
HD Failure: If DVR fails to detect the HDD on start up, the system will create an HD failure event.
HD Full: If the DVR is not set to Overwrite in the Record Menu, an event will be created when the HDD
is filled.
HD Off: If HDDs are switched off or are removed, the DVR will create an HD OFF event.
Power Loss: If power is disconnected, an alarm event will be triggered when power is restored.
Network Loss: If connection to the local network is lost, DVR will create a Network Loss event.
NOTE: This function only checks the physical connection (link) to the network. Any network behavior
that blocks data connectivity (blocked ports, IP addressing errors, etc.) is not detected by this function.
GPS Loss: If the GPS signal is lost, the DVR will create a GPS Loss event.
Click button to return to the previous level of menu.