Casio CTK-7200 - Manual (Page 100)

Using the Song Sequencer
E-98
1.
Display the event editor screen of the track you
want to edit.
• See “To select a track for editing” (page E-91).
2.
Depending on the type of adjustment you want
make, perform one of the operations below.
3.
While holding down the R-13 (FUNCTION)
button, press the C-17 (MENU) button to display
the event editor menu.
4.
Use the R-17 (t, y) buttons to move the 0 to
“VelocityMod.” and then press the R-16
(ENTER) button.
• This displays the “Velocity Modify” screen.
5.
Use the dial or R-14 (–, +) buttons to change the
mode indicated in the thick brackets (%).
• While the “Locator” mode is selected, use the R-17 (u,
i) buttons, the dial, or the R-14 (–, +) buttons to
specify the range whose note event velocity value you
want to adjust.
6.
Press the R-16 (ENTER) button.
• This will display the setting screen like the one shown
below.
• The following explains the meanings and setting ranges
of the on-screen items. The settings marked with an
asterisk (
*) in the “Setting Range” column are initial
defaults.
7.
To change the setting to the desired value,
press the R-16 (ENTER) button.
8.
In response to the “Sure?” message that
appears, press the R-14 (YES) button to execute
the adjustment or the R-14 (NO) button to
cancel.
To adjust the velocity value of a note event
To adjust this: Do this:
Individual note event On the event editor screen,
move the cursor to the note
event you want to adjust and
then advance to step 3.
All note events in a track Advance to step 3.
Note events within a
specific range in a track Advance to step 3.
To adjust this: Select this mode:
Individual note event Cursor
All note events in a track All
Note events within a specific range
in a track Locator
Item name Description Setting Range
Fix
(Fixed value) Specifies a fixed value as the
velocity value.
Select “oFF” for this setting to
adjust based on the current
velocity value of each note
event. oFF * , 001 to 127
Rate
(Velocity Rate) These settings are enabled
only when the “oFF” is
selected for the “Fix” setting.
They change the velocity
value of each note event
according to the mathematical
expression (decimal parts cut
off) shown below. 1 is used
when the value produced by
the expression is less than 1,
and 127 is used when it is
greater than 127.
(Current velocity) X (Rate
setting) + (Offset setting) 000% to 100%
*
to
200%
Offset
(Velocity Offset) –126 to 000
*
to
+126
CTK7200_e.book 98 ページ ２０１４年３月７日 金曜日 午後３時４分