Powerplus POWXG9006 HIGH PRESSURE CLEANER 163CC EN - Manual (Page 5)

POWXG9006
EN
Copyright © 2013 VARO P a g e | 5 www.varo.com

If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.

Always replace and securely tighten the fuel cap after refuelling.

If the tank is drained, this should be done outdoors.
7 SAFETY FEATURES
7.1 Thermal relief valve
A thermal relief valve is provided to protect the pump from overloading if the spray gun is
closed for an extended length of time or the nozzle becomes plugged. However, it is intended
to be used as a backup system and avoid the overheating of the pump.
Switch the pressure washer "OFF", if it will not be used for longer than five minutes. This
reduces wear, prevents fuel consumption and extends the live of the pump by avoiding heat.
7.2 Safety lock off latch
To prevent accidental discharge of high pressure water, the safety lock (picture 1, part 5) on
the trigger should be engaged whenever the pressure washer is not in use (refer to operating
instruction).
8 ASSEMBLY INSTRUCTIONS
Remove all packaging materials from the unit. Check the main unit, its components and all
accessories for loss and transport damages.
8.1 Attach handle and hooks
Attach the handle (picture 1, part 1) and accessory
tray (picture 1, part 3) to the frame of the pressure
washer. Insert carriage bolts (picture 1, part 10)
through holes from outside of unit and attach a
knob from inside of unit. Tighten by hand.
Fit the hose (picture 1, part 8) and lance hooks
(picture 1, part 4) to the upper handle.
8.2 Installing the wheels
Before you fix the wheels (picture 1, part 15) you
have to loosen a screw to take out the axle. Fit a
wheel to the axle and secure using the locking nut
provided.