Powerplus POWXG9006 HIGH PRESSURE CLEANER 163CC EN - Manual (Page 9)

POWXG9006
EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
9.8 Using the detergent facility
Fill a suitable container with pressure washer detergent. Do not use washing up liquid as it
contains salt. We recommend the use of a good quality pressure washer detergent for use
with this pressure washer. Please follow the instructions on the container.
Most automobile detergents are a combination of a detergent and a wax solution, (wash/wax
liquid). These tend to be a thick viscous liquid. The viscosity (thickness) of the detergent will
increase in cold weather. It is recommended that this type of detergent is diluted with warm
water before filling the container. When using combination wash and wax solutions we
recommend that they are diluted before use. As a general guide we would recommend a
dilution rate of 50/50. However a trial and error process would determine the ideal dilution rate
for a particular detergent.
Notes
：

A thick viscous detergent would not flow freely from the detergent tank and the residue
would cause a blockage in the detergent flow system.

After using the detergent facility it should be flushed out thoroughly using copious amounts
of water.
To activate detergent delivery, fit the black low
pressure nozzle to the end of the lance. Submerge
the end of the detergent suction tube (picture 3,
part 25) into your container of pressure washer
detergent. Suction and mixing will occur
automatically as the water flows through the
pump.
10 OPERATING INSTRUCTIONS
10.1 Pressure washer location

Locate the pressure washer on a solid and level surface so that the engine and pump
crankcase oil lubricate components properly. Avoid areas where puddles are pounded.
Slippery surfaces can cause injuries.

Locate the machine in a well-ventilated area and away from flammable materials or fumes.
Be sure ventilation warnings are observed. Keep pressure washer at least 18”away from
flammable materials.

Locate the machine in a way, that the operator has easy access to the pressure washer
and its controls. Locate the machine so that it is protected from external damage.

To prevent damage and excessive hose wear; locate the pressure washer so that the
hose does not cross traffic areas.
10.2 Start-up procedure

Remove all dirt or foreign matter from the gun outlet and the male connector.

Insert the nozzle into the gun.

Start engine.
Warning: lf the wand is not securely locked into place. It could be injected under high pressure
when operation the gun, possibly causing injury or damage.