Epson VIGOR 3300 User Manual
Page 150
Vigor3300 Series User’s Guide
146
7.
After applying the settings, the web page will be redirected to “reboot” web page. You
can ignore it and continue to configure the Network setting. After finishing Network
setting, you can execute the reboot procedure.
8.
After rebooting, the tagged ports will communicate with 802.1Q tagged devices only.
9.
In the Network setting, type the subnet 192.168.1.0 to LAN. For example, the VLAN5
LAN IP is 192.168.1.1 and the Subnet Mask is 255.255.255.0. Then, users in the
Engineer Department can set IP address from 192.168.1.2 to 192.168.1.254.
10.
In the Network setting, type the subnet 192.168.2.0 to LAN2. For example, the VLAN6
LAN IP is 192.168.2.1 and the Subnet Mask is 255.255.255.0. Then, users in the
Engineer Department can set IP address from 192.168.2.2 to 192.168.2.254.
11.
In the Network setting, type the subnet 192.168.3.0 to LAN3. For example, the VLAN7
LAN IP is 192.168.3.1 and the Subnet Mask is 255.255.255.0. Then, users in the
Engineer Department can set IP address from 192.168.3.2 to 192.168.3.254.
12.
In the Network setting, type the subnet 192.168.4.0 to LAN4. For example, the VLAN8
LAN IP is 192.168.4.1 and the Subnet Mask is 255.255.255.0. Then, users in the
Engineer Department can set IP address from 192.168.4.2 to 192.168.4.254.