Epson VIGOR 3300 User Manual
Page 22
Vigor3300 Series User’s Guide
18
End IP
Assign the end IP address of the IP pool that DHCP sever can
use for clients in LAN.
Primary DNS
Type the IP address for primary DNS.
When you finished the above required settings, please click Finish. A system reboot page will
appear. Click Apply to activate the DHCP mode configuration.
2
2
.
.
2
2
.
.
4
4
P
P
P
P
P
P
o
o
E
E
This mode is used for most of DSL modem users. All local users can share one PPPoE
connection to access the Internet. Your service provider will give you the user name, password,
and authentication mode for PPPoE settings.
If your ISP provides you the PPPoE (Point-to-Point Protocol over Ethernet) connection,
please select PPPoE for this router to get the following page. Enter the username and
password provided by your ISP on the web page.
User Name
Assign a specific valid user name provided by the ISP.
Password
Assign a valid password provided by the ISP.
Authentication
Select PAP or CHAP protocol for PPP authentication. The
default value is PAP.
Service Name
Assign a service name required from ISP service.
After setting up the WAN interface, the user can click Next to setup the LAN interface
continuously.