Enlight EN-898X - Manual (Page 12)

12
Cabling the Server Board
After mounting the server board, it needs to be cabled to the
following chassis
the Floppy drive
the disk drive assembly
The front panel
The power supply
3.2 Adding Components to the Server Board
After installing the server board, you must add the desired
number of processor sand memory cards.
3.3 Reattaching the Cover
Once the server board and its components are installed, you
are assembling the system unless you have optional
peripherals you wish to install.
If you need to install these components, continue on to the
next section.
To reattach the cover:
Place the cover on the chassis and slide it forwards as far as
possible.