EverFocus EDSR400M - Manual (Page 20)

Back Panel Connections
Audio IN : Audio input for recording.
Audio OUT : Audio output can be set to “ON” or “OFF” in Setup Menu.
When in recording or standby mode,
the out of SW1 is connected to Audio IN.
Playback Audio
When in playback mode the out of SW1 is
connected to SW2 Audio.
When Playback Audio is enabled then the output
of SW2 will be connected to Playback Audio.
When Playback Audio is disabled then there is no
audio output (MUTE).
When Audio Out is enabled and machine is in Recording or Standby mode, the Audio IN is loop-through to Audio Out
connector.
When Audio Out is enabled and machine is in Playback mode then the Audio Out playback audio.
AUDIO
5 2 4 3 7
1
2
Operation of SW1 : Operation of SW2 :
Audio IN
Audio OUT
OFF / Mute
SW1
SW2
A
( Internal circuit )
5
3. Back Panel Connections
9
1 10 8 6
Main Power plug: Connect the DC12~24V power source to the power input terminal.
POWER