Emerson 90 SERIES 1F95-391 - Manual (Page 38)

36
INDEX
SYMPTOM
Furnace Cycles Too Fast or
Too Slow (narrow or wide
temperature swing)
Cooling Cycles Too Fast or
Too Slow (narrow or wide
temperature swing)
POSSIBLE CAUSE
1. The location of the thermostat
and/or the size of the Heating System
may be influencing the cycle rate.
1. The location of the thermostat
and/or size of the Cooling System
can influence the rate.
CORRECTIVE ACTION
Digital thermostats normally provide precise
temperature control and may cycle faster than some
older mechanical models. A faster cycle rate means
the unit turns on or off more frequently but runs for
a shorter time so there is no increase in energy use.
If you would like to increase the cycle time, refer to
the Installation Instructions under Installer Table for
settings. If an acceptable cycle rate is not achieved
by the adjustment in the Installer Table then you
may want to contact a local heating and air condi-
tioning service person for further suggestions.
The cycle rate for cooling is fixed and can not be
adjusted. Contact a local service person for sugges-
tions.