Sealey SSC11003 - Manual (Page 6)

Original Language Version
screw tail-piece attachment (2) into drain tap(3) below sight
glass. Attach suitable hose and open tap to drain.
once emptied, close drain tap and
remove hose and tail-piece.
fill with oil through plug hole (1) until oil is half way up the
sight glass (4). Replace plug and refit shroud.
Once the oil and oil filter have been changed
leave the compressor to run for roughly 5
minutes then turn it off and check the oil
level again. Add oil if necessary.
check the oil level once a week.
6.3. REPLACING THE OIL FILTER CARTRIDGE.
6.3.1. Replace the oil filter cartridge after the first 500 hours of use
then every 2500 hours and in any event each time the oil is
changed.
6.3.2. remove the upper plastic shroud to gain access
to inside the compressor.
6.3.3. Remove filter cartridge (fig.9.1.) using a strap wrench and
replace with a new one.
6.3.4. Lubricate the sealing gasket before screwing the filter
cartridge tight.
6.3.5. Tighten the new filter cartridge manually.
6.4 REPLACING THE OIL SEPARATOR FILTER CARTRIDGE.
6.4.1. Replace the oil separator filter cartridge after the first 500
hours of use then every 2500 hours and in any event
each time the oil is changed.
6.4.2. remove the upper plastic shroud to gain access to inside
the compressor.
6.4.3. Remove filter cartridge (fig.10.2.), using a strap wrench and
replace with a new one.
6.4.4. Lubricate the sealing gasket before screwing the filter
cartridge tight.
6.4.5. Tighten the new filter cartridge manually.
6.5. REPLACING THE AIR FILTER CARTRIDGE.
6.5.1. remove the upper plastic shroud to gain access to inside
the compressor.
6.5.2 open the plastic cover.
6.5.3. Replace the air filter cartridge and replace the cover.
ssc11003 Issue: 1 - 03/05/13 © Jack sealey Limited
fig.7 fig.8
fig.9
fig.10
fig.11