Emotiva ERC-2 - Manual (Page 17)

17
CHANGING THE REMOTE CONTROL BATTERIES
Emotiva recommends using high quality AAA batteries in the ERC-2 remote control.
To change the remote control batteries you will need a flat tipped Phillips #2 screwdriver!
DO NOT attempt to use a different size bit or damage will occur!
Remove the six (6) Philips head screws on the back of the remote. Make sure you use the
proper size screwdriver so you do not damage the screw heads. This should be performed on a
stable surface. Take care not to lose any of the screws. If you lose any of the screws bring one
of the remaining screws to your local hardware store, they should be able to find you an
adequate replacement.
Turn the screw counter clockwise gently so not to damage the screw heads. When all six (6)
screws are removed, remove the back panel.
Remove the old batteries and discard according to battery maker’s instructions. Insert new
batteries making sure they are installed correctly. Use diagrams in the battery slots for
reference.
Place the back panel back on the remote and reinstall the six (6) screws, turning clockwise
gently until a snug fit is achieved. Do not over tighten the screws as you may damage the screw
heads and/or screw holes in the back of the remote.
Your remote is now ready to use.