Emotiva ERC-2 - Manual (Page 18)

18
OPERATING INSTRUCTIONS
LOADING & EJECTING DISCS
1. Press the Standby/On button, make sure unit is on.
2. The display will read EMOTIVA for a few seconds at power up. LOADING will then
appear on the screen. The player will then say READY. Insert disc into the slot-loader
gently. Do not push hard. Allow the slot-loader to take the disc from your hand; there will
be a short delay. (If the ERC-2 does not say READY at power up, a disc is already in the
player. The disc will start playing automatically. Press STOP and then EJECT to eject the
disc.
Note:
• Do not put anything except a Compact Disc into the slot loader; foreign objects may
damage the ERC-2.
• Do not force discs into the slot-loader.
• If the Compact disc is too dirty or scratched the disc may not play.
• Never load more than one disc into the player at one time.
NORMAL DISC PLAY
Switch on your pre/pro and amplifier or receiver and select the input the ERC-2 is
connected to. Make sure your volume control is turned all the way down.
1. Press the Standby/On switch
2. Insert disc into the slot-loader (Do not force the disc. Allow the slot-loader to take the disc
from your hand.)
3. The ERC-2 will read the disc and begin to play automatically.
4. To stop the disc at any point press the Stop button. Pressing the Play/Pause button while
the disc is playing will pause the disc. When the disc is paused the display will read
PAUSE. Play can be resumed by pressing the Play/Pause button again.
LOCATING A SPECIFIC TRACK
1. Make sure that a disc is in the player
2. Pressing the Next Button on the either the ERC-2 or the remote control will forward the
CD by one track. Repeat as necessary to find the desired track.
3. Press Play and the disc will play to the end of the disc.
4. Pressing the Previous Button on either the ERC-2 or the remote control will access the
previous track.
5. Press a number on the remote control and the corresponding track will be played.