EPoX Computer KP6-FX2 - Manual (Page 24)

KP6-FX 2 3-5
• Gate A20 Option: This refers to the way the system addresses memory
above 1MB (extended memory). The default value is Fast.
Normal: The A20 signal is controlled by keyboard controller or chipset
hardware.
Fast: The A20 signal is controlled by Port 92 or chipset specific
method.
• Typematic Rate Setting: This determines the keystrokes repeat rate.
Enabled: Enable typematic rate and typematic delay programming.
Disabled: Disable typematic rate and typematic delay programming. The rate
will be controlled by keyboard controller in your system.
• Typematic Rate(Chars/Sec):
6 : 6 characters per second. 8 : 8 characters per second.
10: 10 characters per second. 12: 12 characters per second.
15: 15 characters per second. 20: 20 characters per second.
24: 24 characters per second. 30: 30 characters per second.
• Typematic Delay(Msec): When holding a key, the time between the first and
second character displayed.
250 : 250 msec.
500 : 500 msec.
750 : 750 msec.
1000: 1000 msec.
• Security Option: This category allows you to limit access to the system and
Setup, or just to Setup. The default value is Setup.
System:
The system will not boot and the access to Setup will be denied if
the correct password is not entered at the prompt.
Setup: The system will boot; but the access to Setup will be denied if the
incorrect password is not entered at the prompt.
• PCI/VGA Palette Snoop: This filed controls the ability of a primary PCI
VGA controller to share a common palette (When a snoop write cycles) with
an ISA video card. The default value is Disabled.
Enabled: If an ISA card connects to a PCI VGA card via the VESA connec-
tor and that ISA card connects to VGA monitor and that ISA card
uses the RAMDAC of PCI card.
Disabled: Disable the VGA card Palette snoop function.
• Video BIOS Shadow: It determines whether video BIOS will be copied
to RAM, however it is optional from chipset design. Video Shadow will
increase the video speed.
Enabled: Video shadow is enabled.