EPoX Computer KP6-FX2 - Manual (Page 39)

39
Award BIOS SETUP 3-20
Maximum HDD size:
no. Cylinder (1024)
x no. Head ( 32)
x no. Sector ( 63)
x bytes per sector ( 512)
1 GigaByte
Note: To support LBA or LARGE mode of HDDs, there must be some
software involved. All the software is located in the Award HDD Service
Routine (1NT 13h). It may fail to access a HDD with LBA (LARGE) mode
selected if you are running under a Operating System which replaces the
whole 1NT 13h.
UNIX operating systems do not support either LBA or LARGE and must
utilize the Standard mode. UNIX can support drives larger than 528MB.
3-10 HDD LOW LEVEL FORMAT
Interleave:
Select the interleave number of the hard disk drive you wish to perform a low
level format on. You may select from 1 to 8. Check the documentation that
came with the drive for the correct interleave number, or select 0 for auto-
matic detection.
Auto scan bad track:
This allows the utility to scan first then format by each track.
Start:
Press<Y>to start low level format.
3-11 SAVE & EXIT SETUP
The "SAVE & EXIT SETUP" option will bring you back to boot up proce-
dure with all the changes you just recorded in the CMOS RAM.
3-12 EXIT WITHOUT SAVING
The "EXIT WITHOUT SAVING" option will bring you back to normal
boot up procedure without saving any data into CMOS RAM. All old data in
the CMOS will not be destroyed.