Emerson Liebert XDR - Manual (Page 13)

General Product Information
7
Figure 6 Remove Liebert XDR from pallet
3.2.4 Removing the Liebert XDR from the Pallet
1. Unfold the module bag to expose the Liebert XDR.
2. Compare the serial tag information on the Liebert XDR to the bill of lading information. If the
information does not match the product specified, contact your local sales representative.
3. At least two properly trained and qualified personnel may lift the Liebert XDR off the pallet using
the four handles and stand it upright, supporting the module to keep it from falling.
4. If the Liebert XDR will not be installed immediately, lay a piece of protective material the length
of the module on a flat surface and lay the Liebert XDR on it.
!
WARNING
Risk of 130-pound (59 kg) module falling. Can cause equipment damage, personal injury or
death.
Do not leave a Liebert XDR standing unattended on its side or its end without adequate
support to prevent it from falling over. The Liebert XDR must be supported at all times or laid
flat on protective material until it is installed.
Two properly trained and qualified people are required to move the module.
Two people are required
to remove the module from the pallet
and remove the bag