Emerson Liebert XDR - Manual (Page 2)

I
MPORTANT
S
AFETY
G
UIDELINES
SAVE THESE INSTRUCTIONS
NOTICE
Risk of overhead interference. Can cause module or structural damage.
The module may be too tall to fit through a doorway while on the skid. Measure the module
and doorway heights and verify clearances by referring to the installation plans and other
site-specific drawings and documents before moving the module.
Fluorinated Greenhouse Gas Requirements—European Union
Stationary air conditioning, refrigeration, heat pump equipments and stationary fire protection systems in
the European Community market and operating with fluorinated greenhouse gases (f-gas), such as R407C,
R134a, R410A, must comply with the F-Gas Regulation: (EC) No. 842/2006 (F-gas). The regulation prohibits,
among other actions, venting fluorinated greenhouse gases to the atmosphere.
The F-Gas Regulation also requires operators to use all measures that are technically feasible and do not
entail disproportionate cost to prevent leakage of these gases, to test for leakage regularly and to recover f-gas
during equipment service and maintenance and before disposing of equipment.
Refer to the full regulation for additional details.
!
WARNING
Risk of top-heavy module falling over. Can cause equipment damage, personal injury or
death.
Improper handling can cause equipment damage, injury, or death. Read all of the following
instructions before attempting to move, lift, remove packaging from the module, or preparing
module for installation.
!
WARNING
Risk of explosive discharge of high-pressure refrigerant. Can cause personal injury or death.
This module contains fluids and/or gases under high pressure. Relieve system pressure before
cutting into or disconnecting piping or piping components.
!
WARNING
Risk of piping and component rupture. May cause equipment damage, personal injury or
death.
Closing service valves may isolate liquid refrigerant, causing high pressure and rupture of
piping. Do not close valves without following recommended procedures for repair,
maintenance and replacement of components. Install pressure relief valves in field piping
that may become isolated by service valves.
!
CAUTION
Risk of sharp edges, splinters and exposed fasteners. Can cause personal injury.
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move, lift, remove packaging from, or prepare module for
installation.
!
CAUTION
Risk of improper operation and overpressurization. Can cause in personal injury or property
damage.
Only personnel properly trained and qualified in HVAC installation or service should install
or service this equipment.
Read all installation, operating and safety instructions before proceeding.