Extron Electronics HVA - Manual (Page 26)

Operation, cont’d
CrossPoint Matrix Switchers • Operation 3-6
blinking selections, or toggled off by pressing the associated output
button.
Example 1: Create a set of video and audio ties
See figure 3-4 and the following steps for an example in which input 5 is tied to
outputs 3, 4, and 8.
This example assumes that there are no ties in the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
4 8 ESC
RGBHV AUDIO
A
B
ENTER
E
3
D
C
B F
B LED key: = off, = on, = blinking,
= flash once F
Press
Press Press
Press
Press Press
Press
Press
5
B B
Figure 3-4 — Example 1: Creating a tie
A Press and release the Esc button. The Esc LED flashes once.
B If necessary to select video and audio for the tie, press and release the RGBHV
and Audio buttons until the RGBHV and Audio LEDs light.
C Press and release the input 5 button. The input 5 LED lights.
D Press and release the output 3, output 4, and output 8 buttons. The output 3,
output 4, and output 8 LEDs blink to indicate a tentative tie.
The entire set of ties can be aborted at this point by pressing and releasing the
Esc button. The Esc LED flashes once.
E Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now defined as video and audio input 5 tied to video
and audio output 3, output 4, and output 8.
Example 2: Add a tie to a set of video and audio ties
See figure 3-5 and the following steps for an example in which a new video tie is
added to the current configuration.
A Press and release the Esc button. The Esc LED flashes once.
B If it is necessary to select video-only for the tie, press and release the RGBHV
and Audio buttons until the RGBHV LED lights and the Audio LED is off.
C Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate ties created in Example 1.
D Press and release the output 1 button. The output 1 LED blinks to indicate a
tentative tie.
E Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now defined as video input 5 tied to video output 1,