Extron Electronics HVA - Manual (Page 32)

Operation, cont’d
CrossPoint Matrix Switchers • Operation 3-12
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
3 4
D
3 4
3 4
E
F
D
E
Hold Hold
Hold
Press
VIEW
F
Hold
B B
B LED key: = off, = on, = blinking,
Figure 3-12 — Example 5, step D: Muting and unmuting outputs
Using presets
The current configuration (configuration 0) can be saved as a preset in any one of
12 preset memory addresses (CrossPoint 84, 88, 124, and 128) or 16 preset memory
addresses (CrossPoint 168 and 1616). Each CrossPoint switcher has as many
presets as input buttons.
1. Only the audio and video ties are stored and recalled; audio gain settings
are not saved, and do not change when a preset is recalled.
2. Presets cannot be viewed from the front panel unless recalled as the
current configuration. Presets can be viewed using Extron’s Windows-
based control program, see chapter 5, Matrix Software, for more details.
3. The current configuration and all presets are stored in non-volatile
memory. When power is removed and restored, the current configuration
is still active and all presets are retained.
4. When a preset is recalled, it replaces the current configuration, which is
lost unless it is also stored as a preset. The recalled preset overwrites all of
the current configuration ties in favor of the preset configuration ties.
Example 6: Save a preset
See figure 3-13 and the following steps for an example of saving the current
configuration as a preset.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
ESC
A
1
C
PRESET
B
C
B
B LED key: = off, = on, = blinking,
= flash once F
F
F
Hold
Press
Press
Figure 3-13 — Example 6: Saving the current configuration as preset 1