Extron Electronics HVA - Manual (Page 29)

3-9 CrossPoint Matrix Switchers • Operation
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
ESC
VIEW
A
B
C
RGBHV AUDIO
C
LED key: = off, = on,
= flashes once F
F
2 7 6 5
Press
Press
Press
Press
Figure 3-8 — Example 4: Viewing the current configuration, no input
selected
Example 4 shows the process of viewing the current configuration after the
steps in Examples 1, 2, and 3 have been performed.
A Press and release the Esc button. The Esc LED flashes once.
B Press and release the View button to enter view-only mode. The View LED
lights.
C If necessary to select both video and audio for viewing, press and release the
RGBHV and Audio buttons until the RGBHV LED and Audio LED light.
With no input LED selected, all output LEDs that have no established ties
light.
D Press and release the input 5 button (figure 3-9). The input 5 LED lights.
If ties are established for input 5, all output LEDs toggle; outputs with no ties
turn off and the LEDs associated with all outputs tied to input 5 (audio, video,
or audio and video ties) light. If no ties are established for input 5, all output
LEDs turn off.
If audio is broken away, the Audio LED blinks.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
D
RGBHV AUDIO
LED key: = off, = on, = blinking
1 8 4 3
D
5
D
B
B Press
Figure 3-9 — Example 4, step D: Viewing the current configuration,
video and audio
A set of ties can also be viewed by selecting a tied output. To demonstrate this,
note the number of a lit output LED and press and release the output button
for an unlit (untied) output LED. Observe that all of the untied outputs light.
Then press the output button for the output LED noted previously and observe