Silvercrest Electrical Sockets - Manual (Page 5)

9 GB/IE
Setting up
ton 2 of one channel. In addition,
you can programme six remote
controls one after the other and use
them for individual receivers. This
means you can switch one appliance
on and off from up to six different
places.
6. In this case, synchronise every remote-
controlled socket with the channel
of the remote control.
7. The coding of the remote control is
maintained when you change the
battery.
8. If you disconnect the remote-con-
trolled socket from the power supply,
the codings will be permanently
stored.
9. In order to delete the codings again,
press the LEARN button 7 longer
than 6 seconds until the LED oper-
ating status display
6 starts to flash.
All codings will now be deleted.
10. Avoid interference: Make sure that
the distance between the various
remote-controlled sockets is ap-
prox. 50 cm.
11. Every remote-controlled socket also
has a manual ON / OFF switch 5 .
You can switch the remote-controlled
socket on and off without using the
remote control. The LED operating
status display
6 will indicate
whether the remote-controlled sock-
et is in the ON / OFF mode.
Q
Setting up the remote-
controlled dimmer socket
(FSD B 20-A) (fig. B)
1. Insert the remote-controlled socket
into an earthed household socket
and switch it on with the ON / OFF
switch
5 .
2. Point the remote control at the remote-
controlled socket at a distance of
approx. 50 cm.
3. Press the LEARN button 7 of the
remote-controlled socket for ap-
prox. 3 seconds and release it again.
The LED operating status display
6
will flash for approx. 10 seconds.
While it is flashing, press the desired
ON button of the channel ON /
OFF button
2 (A, B, C or D) of the
remote control. The LED operating
status display
6 will now shine
permanently. You can now switch a
connected consumer on or off using
the remote control.
4. The coding of the remote control will
be maintained even when you
change the battery.
5. When you unplug the remote-con-
trolled sockets from the power supply,
the codings will be stored perma-
nently.
6. Avoid interference: Make sure that
the distance between the various
remote-controlled sockets is ap-
prox. 50 cm.
7. In order to delete the codings again,
press the LEARN button 7 longer
than 6 seconds until the LED oper-
ating status display
6 starts to flash.
All codings will now be deleted.
66538_silv_Funkschaltset_Content_GB-IE.indd 9 29.06.11 11:45