Silvercrest Electrical Sockets - Manual (Page 8)

12 GB/IE
Setting-up operation / Cleaning / Disposal
Prob-
lem The operating indica-
tor
1 on the remote
control device illumi-
nates but there is no
reaction
Rem-
edy · Check that the current
output from the battery is
adequate. If necessary
insert a new battery.
Prob-
lem no indicator light 1
on remote control
when pressing “on”
or “oFF”
Rem-
edy · Check that the battery
has been put in correctly.
· Check that the battery
has good contact with the
clamps, if need be press
it onto them.
Prob-
lem no reaction from
consumer
Rem-
edy · Check that the appliance
is switched on.
· Assign a new code to the
radio-controlled socket
(see “Setting up the re-
mote-controlled socket“,
Point 3 or “Setting up the
remote-controlled dimmer
socket“, Point 3).
· Check - by walking closer
to it - that the range is
correct for the desired
location.
Prob-
lem Range is too small
Rem-
edy · For large ranges, ensure
that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar frequen-
cy. Whenever this remote
control is active, the range
declines (e.g. wireless
headphones, radio-con-
trolled movement alarms,
radio gongs etc.).
Q
Cleaning
J Ensure that no liquids get into the
inside of the device. Use a soft cloth
to clean the housing. Never use
petroleum, solvents or cleaners
which corrode plastics.
j Before cleaning, always disconnect
the radio-controlled socket from the
wall socket and remove all power
plugs from the device.
Q Disposal
Electrical appliances
must not be disposed
of with domestic waste.
66538_silv_Funkschaltset_Content_GB-IE.indd 12 29.06.11 11:45