Silvercrest SFN 1.5 A1 - Manual (Page 83)

GPS Outdoor Computer SFN 1.5 A1
English 81
2. Wrap the slightly ribbed side of the non-slip rubber mat around the handlebar (with the smooth
side pointing at the handlebar mount) and fit the semicircular insert on the handlebar mount
to it. Make sure that the unlock lever on the GPS holder is pointing downwards and the bowl
in which the GPS device is placed is pointing towards the bike rider (not in the direction of
travel!).
3. Feed the tongues of the cable ties around the handlebar and through the cube-shaped locking
mechanism of the cable tie. The teeth on one side of the cable tie (the other side is smooth)
need to be on the inside, i.e. pointing at the handlebar. Do not pull the cable ties tight just yet.
When you guide the cable ties through and tighten them slightly, if you do not
hear a slight 'tearing' noise then the cable ties are the wrong way round (with
the teeth facing outwards). In this case, remove the cable tie from the closing
mechanism and re-insert it properly.
4. Place your GPS device in the bowl of the GPS holder. The display (2) should point at the rider
and the USB port (6) should face down. This means making sure the two rails on the holder
are fitted into the correct slots (3) on the device and pushing the device down until you hear it
click into place.
5. Get onto your bike. You can now adjust the device to the optimum position on the handlebar
and tip it slightly so you can see the display (2). Pull the cable ties tight.
We recommend that you tighten the cable ties using a tool (e.g. pliers) and cut off
the excess with scissors.
If you want to use your GPS device on another bike in future, you can either use
the arm belt or cut the cable ties with a tools (e.g. wire cutters) and use two new
cable ties to fit it to the new bicycle. 8 cable ties are supplied. If required, you can
buy more cable ties from hardware or electrical stores.
Removing the GPS device from the bike mount
To remove your GPS device from the bike mount, proceed as follows:
1. Press the unlock lever on the GPS holder and, at the same time, pull the GPS device up out of
the GPS holder.