Silvercrest SKMH 1100 A1 - Manual (Page 96)

94
11. Select speed 1.
12. Press the “ON/OFF” button 11.
The appliance will begin working.
8.3 Steaming with the cooking pot
1. Pour 500 ml water into the blender
jug 6.
2. Place the foods in the cooking pot 21.
3. Place the cooking pot 21 in the blender
jug 6.
4. Close the blender jug 6 with its lid 25
and the lid of the filling opening for the
blender jug with measuring scale 26.
5. Set the desired time.
6. Turn the temperature control 13 to the
right until the display 8 shows “
SF”
(“extra steam”).
7. Select speed 1.
8. Press the “ON/OFF” button 11.
The appliance will begin working.
To remove the cooking pot 21 at the end of
steaming time, see “7.8 Using the spatula”
on page 90.
8.4 Checking whether the food is cooked
Ensure you do not cook foods for too long,
otherwise vegetables become too soft and
meat and fish may become over-dry and
tough.
Warning! A cloud of hot steam
may escape if you remove lid 1 or
25 without sufficient caution
during the cooking process.
To check the state of the food during
cooking, proceed as outlined below.
1. Carefully open the lid for steamer
baskets 1/the lid for the blender jug 25.
When opening the lid, ensure that you
are not hit by a cloud of hot steam.
2. Take the lid right off.
3. Use a relatively long skewer or fork to
check the state of the food being
cooked.
– If the food is ready, press the “ON/
OFF” button 11 to switch the
appliance off.
– If the food being cooked is not yet
ready, put the lid back on and allow
the appliance to continue working.
8.5 Thermal cut-out
The appliance is protected against
overheating. As soon as all the water in the
blender jug 6 has evaporated, allowing the
temperature to get too high, the appliance
switches off automatically.
If this happens, disconnect the appliance
from the power supply and allow it to cool
down.
You can then run the appliance again with
water in it.
RP93471 Küchenmaschine mit Heizung LB5 Seite 94 Donnerstag, 14. August 2014 3:36 15