MCZ Stub - Manual (Page 23)

A B
21
4-INSTALLATION AND ASSEMBLY
The product must always be handled in a vertical position and solely with a cart. Pay particular attention to the door and its glass,
protecting them from mechanical knocks that would compromise their integrity.
Always handle the product with care. If possible, unpack the product near the place of installation.
The packaging materials are neither toxic nor harmful, and therefore no particular disposal measures are required. Storage, disposal or any
recycling is under the responsibility of the end user in compliance with the applicable laws in force.
ASSEMBLING AND ADJUSTING THE FEET
The product requires the support feet to be assembled, whose function is to adjust the product level so that it is aligned and stable on the
ground. The feet are screwed to the base of the structure and they can be installed as shown in the figure and adjusted with a spanner by
acting on the base of the feet.
For an effective closing function of the doors, adjust the feet so that there is a difference of 2 mm between the front and rear of the base
(see figure).
A = B+2 MM
Technical Dept. - All rights reserved - Reproduction is prohibited