RISCO Group ProSYS, Interactive Voice Module - Manual (Page 17)

Voice Module Programming and Operations Manual
17
Verifying Local Communication
*
9 CODE 4 3 2
Local communication can be verified by sending an
Announcement message to all MBUs that are connected to the
Audio and Listen-In channels.
NOTE:
This option can also be used by the installer to test and adjust the volume of each
one of the MBU. For this purpose, the tamper alarm is disengaged when the
installer code is entered, enabling the MBU to be opened and its volume adjusted.
To verify local communication:
1.
VOICE MESSAGE:
1) MSG. STRUCTURE
VOICE MESSAGE:
1) MSG. STRUCTURE
From the
Voice Message
menu, select
[3]
Test Message
.
2.
TEST MESSAGE:
01) SEND MESSAGE
TEST MESSAGE:
01) SEND MESSAGE
Select
[02] Local Play
.
3.
PRESS ANY KEY
TO STOP VM TEST
PRESS ANY KEY
TO STOP VM TEST
The following announcement message is
repeated continuously from all MBUs in the
system:
Test message.
Press any key to stop the announcement.
= NOTE:
If required, the installer can adjust the volume in the MBU(s), as described in the
MBU Operating Instructions on Chapter 5
.