RIGOL DS6000 Series - Manual (Page 42)

RIGOL
10 RP1002C User’s Guide
Certifications and Compliances
EC Declaration of
Conformity – Low
Voltage
Low Voltage Directive 73/23/EEC, as amended by
93/68/EEC
Low Voltage Directive 73/23/EEC, as amended by
93/68/EEC
EN 61010-1/A2:1995: Safety requirements for
electrical equipment for measurement, control and
laboratory use - Part 1: General requirements .
EN 61010-2-032:1995: Safety requirements for
electrical equipment for measurement, control and
laboratory use - Part 2-032: Particular requirements
for hand-held current clamps for electrical
measurement and test.
Additional
Compliance
IEC61010-1/A2:1995: Safety requirements for
electrical equipment for measurement, control and
laboratory use - Part 1: General requirements
.
IEC61010-2-032:1994: Safety requirements for
electrical equipment for measurement, control, and
laboratory use - Part 2-032: Particular requirements
for hand-held current clamps for electrical
measurement and test.
Installation
(Overvoltage)
Category
CAT III: Equipment in a fixed industrial location
(usually permanently connected)
CAT II: Equipment at this level includes appliances,
portable tools, and similar products. Equipment is
usually cord-connected.
CAT I: Secondary (signal level) or battery operated
circuits of electronic equipment.
Pollution Degree A measure of the contaminates that could occur in
the environment around and within a product.
Products should be used only in the environment for
which they are rated.
Pollution Degree 1:
No pollution or only dry, nonconductive pollution
occurs. Products in this category are generally
encapsulated, hermetically sealed, or located in clean
rooms.
Pollution Degree 2:
Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused
by condensation must be expected. This location is a
typical office/home environment. Temporary
condensation occurs only when the product is out of
service.