RIGOL DG4000 Series - Manual (Page 33)

Chapter 1 Quick Start RIGOL
DG4000 Series User’s Guide 1-9
13. Direction Keys
When using the knob and direction keys to set parameters, the direction keys
are used to switch the digits of the number.
During filename input, they are used to move the cursor.
14. Waveforms
Sine----Sine
Generate a Sine waveform with frequency from 1μHz to 160MHz.
 When the function is enabled, the backlight of the button turns on.
 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low
Level and Start Phase of the Sine waveform.
Square----Square
Generate a Square waveform with frequency from 1μHz to 50MHz and variable
duty cycle.
 When the function is enabled, the backlight of the button turns on.
 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low
Level, Duty Cycle and Start Phase of the Square waveform.
Ramp----Ramp
Generate a Ramp waveform with frequency from 1μHz to 4MHz and variable
symmetry.
 When the function is enabled, the backlight of the button turns on.
 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low
Level, Symmetry and Start Phase of the Ramp waveform.
Pulse----Pulse
Generate a Pulse waveform with frequency from 1μHz to 40MHz and variable
pulse width and edge time.
 When the function is enabled, the backlight of the button turns on.
 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low
Level, Pulse Width/Duty Cycle, Leading Edge Time, Trailing Edge Time and
Delay of the Pulse waveform.
Noise----Noise
Generate a Gauss Noise with 120MHz bandwidth.
 When the function is enabled, the backlight of the button turns on.