RIGOL DG4000 Series - Manual (Page 57)

Chapter 2 Basic Waveform Output RIGOL
DG4000 Series User’s Guide 2-1
Chapter 2 Basic Waveform Output
DG4000 can output basic waveforms (including Sine, Square, Ramp, Pulse and
Noise) from one of the channels separately or from the two channels at the same
time. At start-up, the instrument outputs a sine waveform with 1kHz frequency
and 5Vpp amplitude by default. This chapter introduces how to configure the
instrument to output various basic waveforms.
Subjects in this chapter:
 To Select Output Channel
 To Select Basic Waveform
 To Set Frequency
 To Set Amplitude
 To Set DC Offset Voltage
 To Set Start Phase
 Align Phase
 To Set Duty Cycle
 To Set Symmetry
 To Set Parameters for Pulse
 To Enable Output
 Basic Waveform Output Example