Rose Electronics Vista AV - Manual (Page 5)

INTRODUCTION
Vista AV Installation and Operations Manual 1
System Introduction
Thank you for choosing the Vista AV from Rose Electronics for your DVI
video switching applications. The Vista AV is a very versatile product that
can switch the DVI-D input signals from your PC or Mac computers to a
common DVI monitor. Selection can be made using the front panel push
buttons or by sending commands from a controlling computer to the RS232
port on the unit.
The Vista AV is available in four models, the 1x2, 1x4, 1x8, and 1x16. All
models operate and function in the same manor. When the input DVI-D
video source is selected, it is instantly displayed on the output DVI monitor
at resolutions up to 1920 x 1200.
About this manual
This manual covers the installation, configuration, and the operation of the
Vista DVI switching system. The system consists of the Vista DVI unit, the
connected computers, the output DVI monitor, and a computer to send
switching commands to the unit. The Installation section describes how all
components are interconnected to form a seamless video switching system.
Product Registration
Register your product for future updates at: www.rose.com/htm/online-
registrationform.htm.
Disclaimer
While every precaution has been taken in the preparation of this manual, the
manufacturer assumes no responsibility for errors or omissions. Neither
does the manufacturer assume any liability for damages resulting from the
use of the information contained herein. The manufacturer reserves the
right to change the specifications, functions, or circuitry of the product
without notice.
The manufacturer cannot accept liability for damages due to misuse of the
product or other circumstances outside the manufacturer’s control. The
manufacturer will not be responsible for any loss, damage, or injury arising
directly or indirectly from the use of this product.