Rose Electronics CrystalView EX5 DVI - Manual (Page 11)

INSTALLATION
CrystalView EX5 Installation and Operations Manual 7
System Installation
Before installing the CrystalView EX5, pre-plan the layout of the computer,
the Transmitter, the Receiver, and the equipment that will be connected to
the Receiver. The Transmitter and Receiver units should be in a location
that is easily accessible. The CAT5e cable should be routed away from
equipment or environments that can cause interference with the data
transmission between the Transmitter and Receiver.
The CrystalView EX5 is installed in a “Point-To-Point” configuration. This is
easily done by connecting a CAT5e* cable (330 ft / 100m) directly from the
Transmitter’s RJ45 port to the Receiver’s RJ45 port.
Figure 2. Typical Installation
Transmitter installation
(Refer to Figure 2)
1. Locate the Transmitter unit near the computer.
2. Connect the supplied USB Type A/B cable to the Transmitter unit’s USB
Type B port and to an available USB (1.1 or 2.0) Type A port on the
computer.
3. Connect the supplied DVI cable to the Transmitter unit’s DVI-D port and
to the DVI video port on the computer.
4. Connect a CAT5e* cable (not supplied) from the Transmitter’s RJ45 port
to the Receiver’s (RJ45) connector.
5. Connect the supplied 5V, 3A power adapter to an AC outlet and to the
Transmitter’s power port.